How to control your TV using your BT TV remote
TV brand Code
Goodmans 2037
Hitachi 2424
JVC 2788
LG 2992
Panasonic 3846
Philips 3951
Samsung 4483
Sharp 4848
Sony 4985
Toshiba 5523
If your make of TV isn’t listed here, you
can nd a full list of brands and codes at
bt.com/help/remote
You can set your BT TV remote to control both your
BT TV box and your TV. Here’s how.
1 Turn on your TV, then look up the four-digit code for your brand of TV
(see the table on the right). Then hold down and until the
blue light on the remote ashes three times.
2
When the ashing stops, enter your code. The blue light will ash
another three times.
3
Hold down until your TV turns o. The blue light will blink while
it turns o.
4
When your TV turns o, let go of and press it again – your TV
should turn back on. Next try Vol
, Vol .
For some TV brands, you need to press instead of . So if it’s
not working, try this step again but press
.
5 If the volume control works, press . And that’s it!
If it doesn’t work, start again from Step 3.
Using your remote to switch to another device
When switching to another device on your TV (like a games console),
press
on your remote, then keep pressing (not the up or
down arrows) to scroll through your choices (like HDMI1).
Maximum volume too low?
If you need to change the volume on your BT TV box after setting up
your remote, hold down
AD
while pressing Vol , Vol .
Once you’ve set up your remote,
you can:
• turn your TV on and o (standby)
• switch to another device
• adjust or mute the volume.
15 Need some help?
To Next Page
Loading...
Need help?
General
