42
If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or visit www.bt.com/producthelp
Help
Phone does not work
• Have you removed the pull tab and are the batteries installed correctly? See page 6.
• Check that the power is correctly connected.
No dial tone
• Is the telephone cord of the base plugged into the phone socket?
• Only use the telephone cord supplied with the phone.
• Check that the power is correctly connected.
Cannot dial out or receive calls
• Check that the power is correctly connected.
• Is the telephone line cord (provided with the product) plugged into the phone socket.
• The batteries may need recharging.
• Has there been a power cut? If so, place the handset back on the base for 10 seconds and try
again. If it still does not work disconnect the batteries and power for 10 minutes, then reconnect
and try again.
You have a dial tone, but the phone will not dial out
• If you are connected to a switchboard, check whether you need to dial an access code.
Handset does not ring
• The ringer volume may be switched off on the handset or the base, see page 23 and 25.
• Check that the power is correctly connected to the base.
• Make sure the handset is registered to the base, see page 39.
No display
• The batteries may be flat, dead or incorrectly inserted.
• Recharge or replace the batteries (any replacement batteries must be rechargeable and of the
same type supplied).
To Next Page
Loading...
Need help?
General
