Using your answering machine 11
8950 Response 75+ UG [2] – 29/09/2008
To delete all messages
1. Wait until playback of all messages has nished and the message counter
begins to count down from 8 to 0. During the countdown, press
.
Your BT Response 75+ announces ‘All messages deleted’.
To adjust the loudspeaker volume
The message playback volume can be set to a level suitable for you. The default
volume setting is 3 (mid-level).
To decrease the volume
To increase the volume
As you press, a beep sounds at the level you are selecting. When the volume is at
its highest or lowest level you will hear 2 beeps.
Message alert beep on/off
Press and hold
to switch between on and off. Your BT Response 75+ will
announce the current message alert status.
Recording your own outgoing message (OGM)
The outgoing message is the message a caller hears when your BT Response 75+
answers a call. Your BT Response 75+ comes with 2 pre-recorded outgoing
messages: one for Answer On mode and one for Answer Only mode.
When set to Answer On your BT Response 75+ will announce, ‘Hello, your call
cannot be taken at the moment, so please leave your message after the tone’.
When set to Answer Only your BT Response 75+ will announce, ‘Hello, your call
cannot be taken at the moment and you cannot leave a message, so please call
later” and callers will not be able to leave a message.
You can use these outgoing messages or you may prefer to record your own.
Please note
If you alter the volume during playback of a
message, the beep does not sound but the
volume will change accordingly.
If the volume level is below mid-volume, it will
automatically return to the mid-volume setting
when any buttons are pressed (for example, if a
message is played back). The volume is unaffected
during remote access or call screening.
To Next Page
Loading...
