BT Response 75+ - Remote Access; Security and Remote Operation

8950 Response 75+ UG [2] – 29/09/2008
16
8950 Response 75+ UG [2] – 29/09/2008
Remote access
By calling your BT Response 75+ from another TouchTone
™
phone, you can
remotely access your answering machine, allowing you to switch it on or off and
listen to your messages and memos.
Your security code
To keep your messages private, your BT Response 75+ requires you to enter a
2-digit security code before you can play back your messages.
For your security code, look at the swing out label on the underside of the machine.
You cannot change the security code.
To operate your BT Response 75+ remotely
1. Dial your BT Response 75+ phone number. When you hear your outgoing message,
press the
button on the phone you are using. You will hear 2 beeps.
2. Enter the rst digit of your security code (within 8 seconds). You will hear
a beep.
3. Key in the second digit of your security code. You will hear another beep.
If you enter the incorrect code, your BT Response 75+ will announce ‘Security
code error. Please enter again’. If you enter the wrong code again, your
BT Response 75+ will announce ‘Security code error. Thank you for calling’
and then end the call.
Once you have entered the correct security code, you can operate your
answering machine remotely using the telephone keypad. See the following
page for the remote access menu.
If you have no messages, your BT Response 75+ will announce ‘You have no
messages’ and wait for 8 seconds for you to enter another remote instruction.
If you have new messages, your BT Response 75+ will announce ‘You have ‘x’
message(s)’, and then play them back to you.
During remote access, the message counter
on your BT Response 75+ will ash
.