Remote access18
8950 Response 75+ UG [2] – 29/09/2008
8950 Response 75+ UG [2] – 29/09/2008
To switch your answering machine on/off
When you hear ‘End of messages’ or ‘You have no messages’, within 8 seconds,
press
. Your BT Response 75+ answering machine will switch off and announce
‘Answer off’.
Press
again within 8 seconds, to switch it back on again. Your BT Response
75+ will announce ‘Answer On’.
To switch between Answer Record and Answer Only mode
When you hear ‘End of messages’, within 8 seconds, press
. Your BT Response
75+ will announce ‘Answer Only on’ or ‘Answer Only off’.
Press
again to change the setting.
To change your outgoing message
When you hear ‘End of messages’ or ‘You have no messages’, within 8 seconds, press
twice. Your BT Response 75+ will beep to let you know it is starting to record.
When you have nished recording your new outgoing message, press and hold
button for one second. Your BT Response 75+ will beep and play back your message.
To reinstate the default outgoing message, press
during playback of your message.
To check your outgoing message
When you hear ‘End of messages’ or ‘You have no messages’, within 8 seconds,
press
. Your BT Response 75+ will play back your outgoing message.
To turn your BT Response 75+ on
This is useful if you forgot to turn on your answering machine before going out.
1. Call your BT Response 75+ and let it ring. It will answer the call after 20 rings.
When you hang-up, the answering machine will be switched on and will
answer calls.
Memory full
If the memory is full, you will have to delete
some messages before your BT Response 75+
will switch to ‘answer on’ mode. After you hear
the ‘memory full’ announcement, you have 8
seconds to enter your security code. You can
then delete messages, see ‘To delete messages’,
page 10.
To Next Page
Loading...
