Bticino 353000 - Resident Code; New Resident Code

16
3.3 Resident code
(only with Sfera Speaker Module 351100/351200/351300 and the associated Sfera Pushbutton
Modules 352000/352100)
To access the programming of a “RESIDENT” code a master code is necessary. Up to 4000 codes
may be saved, one for each apartment.
The keypad module will indicate that the code has been accepted or deleted by means of audible
signals and the switching on of the green LED. If an unrecognised code is entered, programming
will stop. This interruption is confirmed by a long beep, and the red LED coming on.
3.3.1 New resident code
2 Use the pushbutton module (352000 and 352100)
to select the apartment the resident code must be
associated to.
352041/42/43
1 Enter the master code.
The device emits a beep, and the green LED
starts flashing.
The programming procedure starts.
3 Configuration
Apartment 1
Apartment 2
Apartment 3
Apartment 4
This manual refers to the Sfera wired stand-alone Keypad Module or paired with the
Sfera Speaker Module (351100/351200/351300).
If the Sfera Keypad Module is installed linked to the Display Module (352500) refer to
the Display manual for the code programming.