8
3 Configuration
3.1 Master code
(only with Sfera Speaker Module 351100/351200/351300 and the associated Sfera Pushbutton
Modules 352000/352100 or only with the Sfera Keypad Module)
For safety reasons, the system gives the installer the possibility of programming a “MASTER” code.
This can be used to access the programming of the other codes (passepartout and resident codes).
To access programming mode, a master code must be assigned to the device.; up to 20 master
codes may be saved.
The keypad module will indicate that the code has been accepted or deleted by means of audible
signals and the switching on of the green LED. If an unrecognised code is entered, programming
will stop. This interruption is confirmed by a long beep, and the red LED coming on.
3.1.1 New master code
1 Press the programming pushbutton until the green
LED flashes and a confirmation beep is heard.
2 Press the key. 4 Press the key.
A short beep confirms the
programming of the new
master code
3 Enter the code (4
to 9 digits).
To Next Page
Loading...
