24
4.3 Reset
It is also possible to reset the Sfera Keypad Module and delete all the previously set codes; this will
bring the module back to all the default settings.
3 The red LED
comes on for
4 seconds and
then switches
back off.
1 Disconnect the power
supply (BUS), press and hold
down the programming
pushbutton and reconnect
the power supply.
2 Holding down the
pushbutton until an
extended beep is heard.
OFF
OFF
ON
ON
4 Advanced configuration
In entrance panels with keypad and speaker module, wait one minute after the reset
procedure before starting the programming procedure again.
To Next Page
Loading...
