Sfera Keypad Module
Installer manual
9
If the procedure has been successful, the
green LED stays on for approximately 1 second
before starting to flash again.
Enter another code, or finish.
6 Press the programming pushbutton, or wait 30
seconds to exit the procedure.
A short beep and the LEDs switching off indicate that the programming procedure has been
terminated. The Sfera Keypad Module is now ready for normal operation.
During programming, some rules must be followed:
- keys must be pressed consecutively (maximum 2 seconds between pressures);
- the programming sequence must be started within 30 seconds from the moment the
programming pushbutton has been pressed and must be completed in one stage.
5 Re-enter the code to confirm.
Wrong code:
red LED on and long beep
NO
Correct code:
green LED on and short beep.
OK
To Next Page
Loading...
Need help?
General
