5 | Installation BÜCHI Labortechnik AG
28/42 Operation Manual Recirculating Chiller F-305 / F-308 / F-314
R Device is not in operation and has cooled down.
R Recirculating Chiller is not connected to any other device.
u Place a suitable receptacle below the drain tap (3) on the rear of the Recirculating
Chiller to collect the coolant.
u Open the drain tap and allow coolant to run into the receptacle. When doing so,
keep an eye on the minimum fill level mark (see Chapter3.2.3 "Fill level indicator",
page12) unless the tank is to be completely drained.
u Once the desired quantity of coolant has been drained off, close the drain tap
again.
To Next Page
Loading...
