3 Working with the Autosampler K-371
8 K-370/371 Quick Guide, Version B
3 Working with the Autosampler K-371
The methods described in the following just show one of various possibilities. Other procedures are
described in the Operation Manual.
3.1 Defining blanks using the express rack
Select Configurator > Rack and press [New]. Select the Group and User to which you want to
assign the new Rack (for Group definition see chapter 4.1.1).
Press [Page] twice and enter a name for the rack with the blanks.
Select Express by pressing the Tab key
twice.
Press the Enter key .
Press the Tab key again.
Press the Enter key .
Enter the information for Blank 1 and press [Save] and then [Next].
Enter the information for Blank 2 and press [Save] and then [Next].
Enter the information for Blank 3 and press [Save].
Press [Close].
3.2 Defining a sample rack and adding sample information to this rack
Select Configurator > Rack and press [New]. Select the Group and User to which you want to
assign the new Rack.
Press [Page] twice and enter a rack name.
Press [Save]. Press the Tab key and then press the Enter key .
Enter the sample information for Sample 1, then press [Save].
Press [Next] and enter the sample information for Sample 2.
Continue until you have entered all samples.
Press [Save], then press [Close].
3.3 Measuring blanks
Place the blanks for the measurement into the Express rack.
Select Operator > Determination > Rack with sampler and search for the rack you have defined
with the blank samples.
Press the Enter key .
Press [Run] to start the measurement of the blanks.
3.4 Blank consideration for samples in a rack
Select Operator > Determination > Rack with sampler. Search for the Rack with the samples
for which you like to use the blanks and press the Enter key , then press [Blank]. Select [Assign
blanks manually], press the Enter key .
To Next Page
Loading...
