Buchi K-370 - Measuring Samples in a Rack with Blank Consideration

3 Working with the Autosampler K-371
9 K-370/371 Quick Guide, Version B
Select the blank to be considered and press
[Set].
Select the sample(s) with the Tab key and acti-
vate it/them by pressing the Enter key .
Press [Set] and then 4 times [Close].
3.5 Measuring samples in a rack with blank consideration
Place the samples for the measurement into the 20 rack.
Select Operator > Determination > Rack with sampler and search for the rack you have defined
with your samples. Press the Enter key .
Press [Run] to start the measurement of the samples.