Need help?Do you have a question about the Buderus G115 and is the answer not in the manual?
General| Model | G115 |
|---|---|
| Category | Boiler |
| Fuel Type | Oil |
| Heat Exchanger Material | Cast Iron |
| Installation Type | Floor Standing |
| Combustion Type | Atmospheric |
| Dimensions | Varies by model |
| Boiler Type | Hot Water |
| Efficiency | 87% |
Defines minimum distances for exhaust termination placement, considering factors like grade and adjacent structures.
Specifies requirements for the intake air terminal location, including snow level and distance from exhaust.
Outlines general rules for boiler installation and compliance with codes and regulations.
Details the first intake/exhaust termination system option (Part No. AT-4) with zero clearance rating.
Details the second intake/exhaust termination system option (Part No. FT-4) with zero clearance rating.
Describes the flexible stainless steel oil vent pipe option, including length and clearance requirements.
Describes the standard galvanized vent pipe option, including length and clearance requirements.
Step-by-step guide for installing the flexible oil vent, including sealing and support.
Step-by-step guide for installing the galvanized vent pipe, including sealing and elbow limits.
Instructions for installing boiler piping and related connections.
Explanation of the burner's pre-purge and post-purge cycles.
Details on fuel line setup (one-pipe or two-pipe) and mandatory oil filter.
Presents a table of preliminary burner settings for various Buderus models.
Step-by-step guide for annual boiler and vent system inspection and servicing.
Procedure for testing boiler controls and safety devices during annual service.
Lists important warnings for homeowners regarding boiler operation and safety.
Provides general advice on annual servicing and fuel tank maintenance.
Wiring diagram for the Beckett NX Direct Vent Burner.
Wiring diagram for the Carlin EZ-1 HP P10 Burner.
Wiring diagram for the Riello BF with AL1009 Control Burner.
Terminal board wiring for R2107 Logamatic with Beckett NX Burner.
Terminal board wiring for R2107 Logamatic with Carlin EZ 1 P10 Burner.
Terminal board wiring for R2107 Logamatic with Riello BF Burner.
Link to the PDF installation guide for Buderus G115 Direct Vent Oil Boilers.
To Next Page