What to do if the gas valve does not close on my Buderus Logano G124X II/SP Boiler?
- SSean NicholsonJul 27, 2025
If the gas valve on your Buderus Boiler fails to close, the suggested solution is to replace the gas valve.
What to do if the gas valve does not close on my Buderus Logano G124X II/SP Boiler?
If the gas valve on your Buderus Boiler fails to close, the suggested solution is to replace the gas valve.
What to do if I checked 24-V voltage at the gas valve of my Buderus Boiler?
If the 24-V voltage at the gas valve of your Buderus Boiler is OK, the suggested solution is to replace the gas valve.
What to do if the ignition flame goes out on my Buderus Logano G124X II/SP Boiler?
If the ignition flame on your Buderus Boiler goes out, first verify that the thermal element is securely screwed to the gas valves. If it is, then replace the thermal element.
What to do if the ignition flame surrounds the thermocouple and burns evenly with a bluish flame on my Buderus Boiler?
If the ignition flame surrounds the thermocouple and burns evenly with a bluish flame on your Buderus Boiler, the suggested solution is to replace the thermocouple.
Model | Logano G124X II/SP |
---|---|
Category | Boiler |
Fuel Type | Gas |
Heat Exchanger Material | Cast Iron |
Operating Pressure | 3 bar |
Describes the intended purpose of the boilers for heating water and domestic hot water systems.
Explains symbols used for identifying dangers and user instructions.
General safety instructions for safe, economical, and responsible boiler operation.
Safety notes regarding the boiler room, including combustion air, venting, fire danger, and frost protection.
Safety instructions for maintenance and repair work, covering gas explosion risks and system integrity.
Details the main parts of the boilers, including ignition, control units, casing, and burner block.
Critical warnings about risks to life and explosion if start-up instructions are not followed.
Detailed steps for initiating operation of the GA124 SC and G124X II boilers.
Step-by-step guide for manually igniting and starting the G124X SP boiler.
Procedure for safely shutting off the gas supply to the boiler and handling flame roll-out switch.
Steps for normal shutdown using aquastats or Logamatic 2107 control, including frost protection.
Procedure for emergency shutdown in critical situations like fire, prioritizing personal safety.