Contents
Base controller BC10 - Subject to technical modifications.
2
Contents
1 Explanation of symbols and
safety information . . . . . . . . . . . . . . . . . . . . . . . 3
1.1 Explanation of symbols . . . . . . . . . . . . . . . . . 3
1.2 Safety information . . . . . . . . . . . . . . . . . . . . . 3
2 Information about the product . . . . . . . . . . . . 4
2.1 EU Declaration of Conformity . . . . . . . . . . . 4
2.2 Correct use . . . . . . . . . . . . . . . . . . . . . . . . . . 4
2.3 Cleaning the base controller . . . . . . . . . . . . 4
3 Operating the base controller . . . . . . . . . . . . . 5
3.1 BC10 controls . . . . . . . . . . . . . . . . . . . . . . . 5
3.2 Switching ON and OFF . . . . . . . . . . . . . . . . 6
3.3 Selecting the maximum boiler water
temperature for heating mode . . . . . . . . . . 6
3.4 Selecting the set DHW temperature . . . . . 7
3.5 “Burner” LED (ON/OFF) . . . . . . . . . . . . . . . 7
3.6 Resetting faults . . . . . . . . . . . . . . . . . . . . . . . 8
3.7 Selecting manual mode . . . . . . . . . . . . . . . . 8
3.8 Displaying the status . . . . . . . . . . . . . . . . . . 9
4 For contractors . . . . . . . . . . . . . . . . . . . . . . . . . 10
4.1 Inserting the programming unit . . . . . . . . . 10
4.2 Removing the base controller . . . . . . . . . . 10
4.3 Starting operation under partial load . . . . 11
4.4 Carrying out a flue gas test . . . . . . . . . . . . 11
4.5 Setting parameters . . . . . . . . . . . . . . . . . . . 12
4.5.1 Limiting the heating load . . . . . . . . . . . . . . 12
4.5.2 Pump run-on time . . . . . . . . . . . . . . . . . . . . 12
4.5.3 DHW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
4.5.4 Burner fan speed . . . . . . . . . . . . . . . . . . . . 12
4.6 Fault diagnosis . . . . . . . . . . . . . . . . . . . . . . 13
4.7 Resetting the service interval . . . . . . . . . . . 15
5 Environment/disposal . . . . . . . . . . . . . . . . . . . 16
To Next Page
Loading...
