Buderus Logamatic TC100 User Manual

3 Product information
Logamatic TC100 – 6720889234 (2018/10)
3
3 Product information
3.1 Scope of delivery
Fig. 1 Scope of delivery
[1] Logamatic TC100
[2] Quick Install Guide
[3] Screw with rawl plug 2 ×
[4] Wall plate
3.2 Accessories
The following accessories are available:
• Smart Radiator Thermostats
• Logamatic TC100 adaptor
• Logamatic TC100 app (free of charge).
Visit www.buderus-logamaticTC100.com for an up-to-date overview.
3.3 Warranty conditions
A manufacturer's warranty of 2 years is provided for Logamatic TC100.
3.4 Declaration of Conformity (Europe)
Hereby, Bosch Thermotechnik GmbH, declares that the radio
equipment with type TC100.2 are in compliance with Directive
2014/53/EU.
The complete text of the EU Declaration of Conformity is available on the
Internet: www.buderus-logamaticTC100.com/manual.
3.5 Data privacy
Information about data protection can be found on the Logamatic TC100
site under Data protection.
1)
3.6 Data connection
▶ Logamatic TC100 supports open WLAN connections and WLAN
connections encrypted with WEP 128, WPA and WPA2 protocols.
WPA2 is the safest protocol and is therefore preferred.
▶ “Hidden” networks are not supported.
▶ Logamatic TC100 takes over the time setting of the Buderus server.
If there is no connection to the server, Logamatic TC100 can only be
put into operation in manual operation.
▶ All costs for creating an Internet connection and a smart device are to
be borne by the user.
▶ The type of connected heat source determines, which functions can
be used. Consult the Logamatic TC100 site to gain an overview of
which functions are available for which heat source.
1)
3.7 Proximity sensor and touch screen
Fig. 2 Proximity sensor and touch screen
[1] Proximity sensor
[2] Touch screen
A proximity sensor [1] detects a presence in front of the touch screen
[2] and lights up. If nothing more is detected for a short period of time,
the touch screen automatically switches off. If the detection lasts for
longer than 5 minutes, the touch screen automatically switches off.
▶ If required, clean the touch screen with a clean, dry cloth.
3.8 Ambient Light
Logamatic TC100 not only communicates with you via the app, but also
via Ambient Light. As soon as you send a heating command via the app to
Logamatic TC100, it lights orange for a second when you increase the
temperature, and blue when you lower the temperature. When you leave
your home, a green light for a second indicates that the heating system
has automatically switched to away mode. Red light: Error occurred in
your heating system. If everything is running normally, Ambient Light will
be off.
4 Assembly
4.1 Prior to installation
▶ Prior to installation, check that Logamatic TC100 can be combined
with the heat source.
On the Logamatic TC100 site there is a list of possible combinations with
or without the operation of Logamatic TC100.
1)
Minimum requirements for installation:
▶ 2-wire cable to a heat source, which is suitable for use with Logamatic
TC100.
▶ Broadband internet access via WLAN 802.11 b/g (2.4 GHz) for use
with the app and internet functions.
4.2 Determining the installation location
A reference room is a room (for example the living room), where the
temperature, which is representative of the whole dwelling, is measured,
and where most time is spent.
1) See the back of this document for the web address.
0010018147-001
2x
Q
uick install guide
1
2
3
4
0010018148-001
1
2

Buderus Logamatic TC100 Specifications

General

Brand	Buderus
Model	Logamatic TC100
Category	Controller
Language	English