Buderus S32/5 User Manual

2
Product Information
S 32/5 – 6 720 804 007 (2014/10) 5
2Product Information
2.1 Scope of delivery
•Tanks
• Tank drain (factory installed)
• Installation and Maintenance Instructions
• Compensation fields for aquastat or tank temperature sensor
•B-KIT
Fig. 1 B-kit
[1] Tee ¾" x ¾" x ¾"
[2] Temperature and pressure relief valve
[3] Coupling ¾ " (3x)
[4] Holder for Aquastat, screws for Aquastat holder (2x)
2.2 Designated use
The tank is designed for heating and storing drinking water. Please
observe national, regional, and local codes, regulations, guidelines and
standards for drinking water.
Install this tank only in sealed unvented hydronic heating systems.
Any other purpose is considered improper use. Any resulting damage is
excluded from the manufacturer's warranty.
Requirements for drinking water Unit
Water hardness, min. ppm
grain/US gallon
°dH
36
2.1
2
pH value, min. – max. 6.5 – 9.5
Conductivity, min. – max. μS/cm 130 – 1500
Table 3 Requirements for drinking water
6 720 801 772-15.1T
1
2
3
4

Buderus S32/5 Specifications

General

Brand	Buderus
Model	S32/5
Category	Water Heater
Language	English