• E3 頂部溫度感應器故障(開路)
Top lid sensor open circuit
再加熱 RE-HEATING
• E4 頂部溫度感應器故障(短路)
Top lid sensor short circuit
如有顯示以上故障代碼,請送回技術部門維修
If the above error code appear, please send the set to an
authorized service center for repair.
將冷飯均勻攤平在鍋內，在米飯上灑上適量水份。
To reheat cold rice, first loosen the rice with the rice scoop
provided. Sprinkle some water evenly over the rice.
1. 先按“保溫”鍵至指示燈(青)出現。
Press the KEEP WARM button until green indicator light
is on.
2. 按下“開始”鍵，指示燈(紅)出現。LCD 出現 8 分鐘倒
數。
Press COOKING button, red indicator light will be on.
LCD shows 8 minutes count down.
清洗與保養 CARE and CLEANING
清洗前切斷電源並讓電飯鍋完全冷卻。
BEFORE you start to clean your Smart Cooker, ensure that the
power supply is turn OFF. WAIT until the appliance is at room
temperature before start cleaning.
3. 冷飯加熱功能祇限於加熱冷飯，不能加熱冷菜、冷湯。
The REHEAT function is ONLY for re-heating cooked rice
and not for dishes or soups, etc.
1. 內鍋、飯勺、湯勺和上蓋用清潔劑洗淨後，以清水沖洗，然後
用乾軟布擦乾。
The inner pot, rice scoop, soup ladle and lid can be cleaned
with mild soapy water, rinse with clean water and then wipe
dry with a soft clean cloth.
4. 所有烹調功能完成時都會“嗶”3 聲。
The buzzer will beep 3 times when any selected function
is completed.
2. 每次使用後，用乾淨濕布將電飯鍋外面擦乾淨。
Please clean the exterior surface of the rice cooker with a
clean damp cloth after every cooking.
故障代號 ERROR CODE
• E1 底部溫度感應器故障(開路)
Bottom sensor open circuit
3. 清除粘附在電熱盤上的飯粒或其他雜物，以確保內鍋和電
熱盤全面接觸。
Remove any rice or residue on the heating area to ensure
the inner pot is properly in contact with the center
thermostat.
• E2 底部溫度感應器故障(短路)
Bottom sensor short circuit
To Next Page
Loading...
