Need help?Do you have a question about the Buffalo TeraStation Live HS-DHTGL/R5 and is the answer not in the manual?
Connect the power cord to a wall socket and the Ethernet cable to a network device.
Insert the TeraNavigator CD and run setup.exe or type d:\TSnavi.exe.
Utilize 'Shortcut for TS-Live' for folders and 'Buffalo NAS Navigator' for utilities.
Access the web-based configuration GUI using IP address or NAS Navigator.
Configure IP address, subnet mask, gateway, and DNS server settings.
Manage drive properties, RAID arrays, and USB disk settings.
Set up RAID modes, scanning, and error detection for hard drives.
Create, delete, and configure shared folders, access restrictions, and services.
Set up backup jobs, schedules, sources, and destinations for data protection.
General| Model | HS-DHTGL/R5 |
|---|---|
| Category | Storage |
| Form Factor | Desktop |
| Hard Drive Interface | SATA |
| RAID Support | Yes |
| Number of Bays | 4 |
| Network Interface | Gigabit Ethernet |
| USB Ports | 2 x USB 2.0 |
| Drive Type | SATA |
| RAID Levels | 0, 1 |
| Operating System Compatibility | Windows, Mac |
| Storage Capacity | 1TB |
| Max Internal Raw Capacity | 1.0TB, 1.6TB, 2.0TB (depending on model) |
To Next Page