14
Step 3: Place garden hose inside the inner chamber of the lter
cage.
IMPORTANT: Never ll the spa with soft water unless an
appropriate mineral supplement is immediately added (see your
authorized Bullfrog Spas Dealer). If your water is extremely hard,
it is preferable to either dilute the water’s hardness by blending
the water with water from a water softener, using a mineral lter,
or by the addition of a special water softening chemical (see your
authorized Bullfrog Spas Dealer).
Step 4: Fill to the water level indicator line located on the right
side of the grill on the face of the lter plate assembly.
Step 5: Reinstall the lter cap(s) and lter snap cap.
Step 6: Check for leaks: After the spa is lled, check all ttings
and equipment in equipment compartment for signs of leakage
before turning on the spa. Turn on pump(s), once again, check
for leakage. If a leak is detected, tighten the tting by hand. If the
leak persists contact your authorized Bullfrog Spas Dealer.
Step 7: Install Cover: e spa cover comes with tie down
straps and locking hardware that attaches the cover to the spa or
decking. If your dealer did not install the cover, refer to the Cover
Installation Instructions included with the cover.
Cover locks are an essential component for compliance with the
ASTM F1346-91 safety standard for spa covers.
IMPORTANT: e spa cover is a critical feature in main-
taining a safe and secure spa environment. In addition keeping
your spa covered when not in use is important for maintaining
spa water at the desired temperature and saving energy. When
spa is not in use, always place the cover over the spa and secure
by pulling down on the cover strap, clicking the two sides of
the cover clips together, and then locking each clip with the key
provided. e cover should remain in place and locked at all times
when not in use to prevent unauthorized entry and to prevent the
wind blowing it open inadvertantly.
To Next Page
Loading...
