BullFrog A7 - Series Spas Controls & Operation

25
X SERIES SPA CONTROL PANELS
Preparation and Filling
Fill the spa to its correct operating level. Be sure to open all valves
and jets in the spa before lling to allow as much air as possible
to escape from the system during the lling process. For details
see “Filling your spa” section. After turning the power on at the
main power panel, the control panel display will go through
an initializing sequence. is sequence displays information
regarding the conguration of the hot tub control. After a few
seconds, your control will display the Home/Status screen which
shows time, jet and light status, temperature status, operation
mode, etc.
Power
Press any button to turn the keypad on. After 30 minutes without
activity it will shut o.
Priming the Pumps
Pumps must be primed directly after lling to ensure correct
operation of your spa. After initial start up, verify that the home
status screen appears on the panel. To prime the pumps press the
“Jets 1” button once to prime in low-speed. After the pump
turns on and water is visibly owing from the jets wait a few
seconds and then press
“Jets 1” again to initiate high-speed
operation of Pump 1 (if spa is equipped with optional circulation
pump Pump 1 will operate at high speed only). e pump has
primed when water is owing from the jets.
If your spa is equipped with a second jet pump repeat the priming
process for Pump 2 by pressing the
“Jets 2” button once to
turn on low speed and then a second time to turn Pump 2 on
high.*
*NOTE: Depending on the model and conguration, some X
Series spas may have one or more jet pumps that are single speed
only. ese pumps operate at high speed only.
IMPORTANT: Pumps should not be allowed to run without
priming (no water owing out of the jets) for more than 2
minutes. Doing so may cause damage to the pump(s).
NOTE: Sometimes momentarily turning the pump o and
on will help it to prime. Do not do this more than 5 times. If the
pump(s) will not prime, shut o the power to the spa and call for
service.
Once you have completed priming, the home status screen will
Jet / Key 1
Press to toggle jets
LOW/HIGH/OFF
Jet / Key 2
Press to toggle jets
LOW/HIGH/OFF (for
spas equipped with
dual pumps)
Lights Toggle
Press to toggle lights
ON/OFF
Down Button
Used to move through
menu selections
Up Button
Used to move through
menu selections
Settings
Audio
X Series Control (with Audio)