20
Jet / Key 1
Press for jets
LOW/HIGH/OFF
Jet / Key 2
Press for jets
LOW/HIGH/OFF
(spas with
2 pumps)
Lights Toggle
Press for lights
ON/OFF
Down Button
Used to move through
menu selections
Up Button
Used to move through
menu selections
Key 5
Settings
Audio
Key 4
Key 6
R SERIES (R800) CONTROL
Start Up
Fill the spa to its correct operating level. Be sure to open all
valves in the JetPaks and all other jets in the spa before lling to
allow as much air as possible to escape from the system during
the lling process. For details see “Filling your spa” section. After
turning the power on at the main power panel, the control panel
display will go through an initializing sequence. is sequence
displays information regarding the conguration of the hot tub
control. After a few seconds, your control will display a standard
status screen with time, jet and light status, temperature status,
operation mode, etc.
Power
Press any button to turn the keypad on. After 30 minutes without
activity it will shut o.
Priming the Pumps
Pumps must be primed directly after lling to ensure correct
operation of your spa. After initial start up, verify that the home
status screen appears on the panel. To prime the pumps press
the
“Jets 1” button once to prime in low-speed. After the
pump turns on and water is visibly owing from the jets wait a
few seconds and then press
“Jets 1” again to initiate high-
speed operation of Pump 1. e pump has primed when water is
owing from the jets.
If your spa is equipped with a second jet pump repeat the priming
process for Pump 2 by pressing the
“Jets 2” button once to
turn on low speed and then a second time to turn Pump 2 on
high.
IMPORTANT: Pumps should not be allowed to run without
priming (no water owing out of the jets) for more than 2
minutes. Doing so may cause damage to the pump(s).
NOTE: Sometimes momentarily turning the pump o and
on will help it to prime. Do not do this more than 5 times. If the
pump(s) will not prime, shut o the power to the spa and call for
service.
Once you have completed priming, the home status screen will
display the set temperature. e system requires approximately
1-2 minutes of water owing through the heater to determine
and display the correct water temperature.
R Series Control with Audio
To Next Page
Loading...
