33
Very Important! After balancing and
before using cartridges, establish an initial
residual of 0.5 - 1.0 ppm free chlorine with
FROG
®
Jump Start
®
start-up shock, includ-
ed in this package, that quickly dissolves
with an effervescent fizzing action – one
packet per 600 gallons.
Heat water to the manufacturer’s recommended
temperature.
4.
5.
Water Balance Guidelines
pH: 7.2 – 7.8
Total Alkalinity: 80 - 120 ppm
Calcium Hardness: 150 - 250 ppm
Total Dissolved Solids: <1500
b. Look at the Total Alkalinity reading first. Adjustments
should be made to bring the Total Alkalinity in the range of
80 – 120 ppm prior to making any adjustments to pH even if
it throws pH off further.
a. Take a water sample from the hot tub
and dip a FROG @ease Test Strip into it.
c. After Total Alkalinity is in range, test for pH. It should be
between 7.2 and 7.8. If higher or lower, add a pH adjuster.
d. Lastly test for Calcium Hardness. It should be between
150 and 250 ppm. If higher, partially drain the hot tub (about 6 inch-
es) and fill with water low in calcium. If lower, add Calcium Increaser.
If balancing takes longer than 2 days shock the water and
maintain a chlorine level while continuing balancing.
Active Ingredient:
Silver Chloride ...........0.5%
Other Ingredients: .....99.5%
Total: ........................100.0%
KEEP OUT OF REACH OF CHILDREN
CAUTION
It is a violation of Federal Law to use this product
in a manner inconsistent with its labeling.
To Next Page
Loading...
