Page 9
NOTE: Access to the remaining functions in LEVEL 2 is intended for trained service personnel only.
More in depth information can be found in the Axiom Service Manual 39132.0000
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
ENTER ASSET # ?
NO YES
SET READY: 195°
(-) DONE (+)
SET TEMP: 200°
(-) DONE (+)
UNITS
METRIC DONE ENG
SET LANGUAGE
NO YES
SET PASSWORD
0 0 0
ADJUSTMENTS & OPTIONAL SETTINGS (CONT.)
Any 3 digit number may be programmed to prevent unauthor-
ized access of LEVEL 2. BE CAREFUL TO USE A CODE YOU WILL
REMEMBER!
Choose between English or Spanish. After selecting "YES",
press either ( + ) or ( - ) to select, then choose "YES" again
when asked, "ARE YOU SURE?"
Choose between English or Metric units. Display will read:
"CHANGING UNITS WILL CAUSE" "ALL SETUP INFO TO BE
LOST" "ARE YOU SURE?" "NO YES". NOTE: If the brewer
is set for Metric Units, displays will be different. (ex: Brew oz
will become Brew Liters, ° F will be ° C).
Adjusts brew tank temperature.
RANGE: (185 to 205° F) or (85 to 96° C)
This function sets the minimum temperature allowable to start
a brew cycle. Range: (2° to 20° F) or (2° to 10° C) below the set
temperature. The water must be at the "READY" temperature
or higher for the display to indicate "READY TO BREW".
This function allows the you to enter in an optional asset num-
ber. This can be useful for tracking the usage or service of an
individual machine within a group.
41154 041708
To Next Page
Loading...
Need help?
General
