Need help?Do you have a question about the Bunn CDS-2 and is the answer not in the manual?
General| Brand | Bunn |
|---|---|
| Model | CDS-2 |
| Category | Beverage Dispenser |
| Language | English |
Safety warnings for servicing electrical equipment and unplugging the dispenser.
Troubleshooting steps for when the dispenser shows no activity, including power and switch checks.
Diagnosing compressor failure, checking power, fuse, contactor, controls, relay, protector, and capacitor.
Further troubleshooting for cooling issues, checking air filter, condenser, and refrigerant.
Steps to diagnose why the auger motor is not turning, checking switch, capacitor, and motor.
Troubleshooting for cooling issues when compressor runs, checking auger and specific LED code.
Diagnosing why the product is not freezing, checking switch, sugar content, and voltage divider.
Troubleshooting for product leaks, checking for worn shafts and seals.
Troubleshooting for cooling issues with specific LED code, checking temperature sensor.
Troubleshooting for incorrect ice granule size, adjusting controls and sugar content.
Troubleshooting for cooling issues with specific LED codes, checking torque sensor circuit board.
Emphasizes qualified personnel for electrical service and disconnecting power.
Steps for testing auger motors, including voltage checks and continuity.
Detailed instructions for removing and installing auger motors and associated parts.
Instructions for replacing the auger motor capacitor, including removal and installation.
Procedures for testing auger motor capacitors using voltage and continuity checks.
Detailed steps for removing and replacing the auger shaft assembly, including lubrication.
Procedures for testing auger switches using voltage and continuity checks.
Instructions for removing and replacing auger on/off switches.
Steps for testing the circuit breaker for continuity and reset functionality.
Instructions for removing and replacing the circuit breaker.
Covers testing of start relay, compressor, and thermal overload protector.
Procedure for checking the continuity of the compressor start capacitor.
Instructions for replacing the compressor start relay.
Procedure for replacing the thermal overload protector.
Detailed steps for removing and replacing the compressor assembly, including refrigerant handling.
Procedure for replacing the thermal overload protector on 120V models.
Instructions for replacing the compressor run capacitor.
Covers testing of start relay, compressor, thermal overload protector, and start capacitor.
Procedure for checking the continuity of the compressor run capacitor.
Instructions for replacing the compressor start capacitor.
Instructions for replacing the compressor run capacitor.
Detailed steps for removing and replacing the compressor assembly, including refrigerant handling.
Instructions for replacing the compressor start relay.
Instructions for replacing the thermal overload protector.
Steps for testing the contactor using voltage and continuity checks.
Instructions for removing and replacing the contactor.
Procedures for testing the switch using voltage and continuity checks.
Instructions for removing and replacing the Day/Night switch.
Procedures for testing the ON/OFF switch using voltage and continuity.
Instructions for removing and replacing the dispenser ON/OFF switch.
Instructions for removing and installing the electronic control board.
Procedure for testing the electronic control using voltage measurements.
To Next Page
