Page 14
PROGRAMMING (cont.)
10. Select SAVE.
11. The display should now show the actual flow rate of the bypass.
12. Repeat steps 1-7 to calibrate the other side. (Twin ICB models only)
RENAMING A RECIPE
There are 5 pages containing 6 recipe names (30 total). By default, recipe names are preset from the factory.
The operator has the choice of renaming any recipe.
1. Touch the BUNN logo for 2 seconds to enter SERVICE ACCESS.
2. Select the ADVANCED icon.
3. At the PASSWORD ENTRY screen, select ENTER (If a password is required, enter the code at this screen).
5. In the SERVICE MENU screen, select the RECIPE icon.
6. The RECIPE EDIT screen will appear on the display. If necessary, use the scroll arrow at the top of the screen
to navigate to the desired recipe name to edit. Select the recipe name.
NOTE: Blue-filled buttons represent recipes with enabled batch sizes; these recipes will appear in the recipe
selection list from the home screen. Grey-filled buttons represent recipes with all batch sizes disabled; these
recipe names will not appear in the recipe selection list from the home screen until a batch size is enabled.
7. Select the white rectangle that contains the current name for the recipe.
8. Use the touchscreen to enter a new recipe name. Select ENTER when finished.
9. Select SAVE to store the new recipe name in programming.
ENABLING/DISABLING BATCH SIZES
The operator has the option to setup a recipe to include up to 3 batch sizes. Disabling all batch sizes for any given
recipe will remove it from the recipe selection list at the home screen.
1. Touch the BUNN logo for 2 seconds to enter SERVICE ACCESS.
2. Select the ADVANCED icon.
3. At the PASSWORD ENTRY screen, select ENTER (If a password is required, enter the code at this screen).
5. In the SERVICE MENU screen, select the RECIPE icon.
6. The RECIPE EDIT screen will appear on the display. If necessary, use the scroll arrow at the top of the screen
to navigate to the desired recipe name to edit. Select the recipe name.
9. Select the desired batch sizes to be offered with the recipe by selecting the white checkbox next to each
batch size icon. Enabling the batch size without editing the batch recipe settings will automatically set recipe
parameters to default settings (volume, bypass, pre-infusion, etc).
10. Select SAVE to keep the changes made to the recipe.
MODIFYING RECIPES
By default, recipe settings are preset from the factory. The operator has the choice of enabling, disabling
and modifying any recipe setting.
HOW TO ACCESS RECIPE SETTINGS
1. Touch the BUNN logo for 2 seconds to enter SERVICE ACCESS.
2. Select the ADVANCED icon.
3. At the PASSWORD ENTRY screen, select ENTER (If a password is required, enter the code at this screen).
050718
To Next Page
Loading...
Need help?
General
