13
TROUBLESHOOTING (cont.)
PROBLEM
PROBABLE CAUSE
REMEDY
1. Change to full BIB or replenish
caddy with more product.
2. Contact authorized service
agent or perform product tub-
ing replacement if authorized
to do so.
3. Remove nozzles and clean
with sanitizing solution to re-
move build-up. Follow Care
and Cleaning instructions and
run sanitizing solution through
system.
4. Follow set-up instructions to
adjust Brix.
1. Assure required water connec-
tion was made properly and if
there’s a shut-off valve, make
sure shut-off valve is open.
Check that water inlet pres-
sure has dynamic operating
pressure between 30 to 90 psi.
If below 30 psi, install water
booster pump for adequate
water pressure to supply line
of dispenser.
2. Follow set-up instructions to
adjust Brix
1. BIB or caddy is empty.
2. Product pump tubing is worn.
3. Build-up is occurring in nozzle
and system needs cleaning.
4. Brix is off target and needs ad-
justment.
1. Water supply is turned off or
too low water pressure from
source/inlet.
2. Brix is off target and needs ad-
justment.
Coffee is Weaker than Desired
Coffee is Stronger than Desired
55124 021418
To Next Page
Loading...