Bunn SmartWave APS - Switch Settings; High Altitude Switch; Energy Save Switch; Brew Lockout Switch

Page 16
1 2 3 4
OFF
ON
FIG 16
SWITCH SETTINGS
Program Switches:
1. Unplug the brewer and let it cool down before proceeding.
2. Remove the brew funnel.
3. Remove the front cover.
4. Flip the dip switches as needed (ON toward rear, OFF toward front)
NOTE: All switches are turned OFF from factory.
FIG 15
KEY # FUNCTION - OFF FUNCTION - ON
4. High altitude Set temp 200°F (93°C) Set temp 190°F (87.8°C)
3. Energy Save No energy save mode Drops to 140°F (60°C) @ 6 hours/OFF @ 26h
2. Brew lockout Brew @ any temp Only brews when it indicates ready
1. Program lockout Programming allowed All programming locked out
40410 092407