What to do if my Bürkert Transmitter shows 'PWR FAIL'?
If the Bürkert Transmitter displays 'PWR FAIL', it indicates that the supply voltage is too low. This could be because the voltage at the device terminals is below 12 V or the impedance of the current measurement loop is too high. To resolve this, adjust the supply voltage to ensure the voltage at the device terminals is between 12 V and 36 V.
What does 'WARN. VOL.' mean on my Burkert Controller?
If the device state LED on your Burkert Controller is orange and displays the message 'WARN. VOL.', it indicates that the daily volume or mass totalizer has reached the value set in the 'VOLUME-W.' parameter of the Test menu. Perform the planned maintenance operation and reset the daily volume or mass totalizer.
Why is the displayed flow rate always nil on my Bürkert Measuring Instruments?
If the displayed flow rate on your Bürkert Measuring Instruments is always nil, ensure the flow rate in the pipe is not nil, check that the entered K factor is correct. Also, consider choosing a smaller flow rate unit or increasing the number of displayed decimals.
What does 'ERROR3' mean on my Burkert Controller and how do I fix it?
If the device state LED on your Burkert Controller is red with the message 'ERROR3', it signifies that the user parameters have been lost. Try restarting the device. If the message persists, reconfigure the device.
What does 'CONTINUE' mean on my Burkert Controller?
If the device state LED on your Burkert Controller is any colour and displays the message 'CONTINUE', it indicates that the power supply was interrupted during a dosing, causing the dosing to be interrupted. Check the electrical installation. You can either abort the current dosing or continue it, but in the latter case, verify that the current dosing is accurate.
Why is the displayed quantity increasing slowly on my Burkert Controller during dosing?
If, during a dosing process, the displayed quantity on your Burkert Controller increases or decreases very slowly and the device state LED is green, check that the K-factor corresponds to the fitting used. You may also perform a Teach-In procedure to determine the K-factor of the fitting used and check that the flow rate in the pipe is high enough.
What does 'ERROR6' mean on Bürkert Measuring Instruments and how to fix it?
If the Bürkert Measuring Instruments displays 'ERROR6', it means totalizer values are definitely lost and both totalizers are reset. Start the device again.
What does 'ERROR4' mean on Bürkert Measuring Instruments and how to fix it?
If your Bürkert Measuring Instruments displays 'ERROR4', it means the totalizer values are lost, and the values saved upon the next to last power down are retrieved. Try restarting the device.
What does 'ERROR3' mean on Bürkert Measuring Instruments and how to fix it?
If your Bürkert Measuring Instruments displays 'ERROR3', it means the user settings are lost, and the device might measure incorrect values. Try restarting the device. If the message continues, reconfigure the device.
What does "MEAS. OVF" mean on Bürkert Measuring Instruments and how to fix it?
If the Bürkert Measuring Instruments shows 'MEAS. OVF', the rotational frequency of the paddle wheel is higher than 250 Hz. Check and adjust the flow rate in the pipe if necessary.
General| Display | LCD |
|---|---|
| Protection Class | IP65 |
| Output | 4-20 mA |
| Output Signal | 4-20 mA |
| Material | Stainless steel |
| Operating Temperature | -15 to +80 °C (depending on material) |
To Next Page
