What does "MEAS. OVF" mean on Bürkert Measuring Instruments and how to fix it?
If the Bürkert Measuring Instruments shows 'MEAS. OVF', the rotational frequency of the paddle wheel is higher than 250 Hz. Check and adjust the flow rate in the pipe if necessary.
What does 'ERROR3' mean on Bürkert Measuring Instruments and how to fix it?
If your Bürkert Measuring Instruments displays 'ERROR3', it means the user settings are lost, and the device might measure incorrect values. Try restarting the device. If the message continues, reconfigure the device.
What does 'ERROR4' mean on Bürkert Measuring Instruments and how to fix it?
If your Bürkert Measuring Instruments displays 'ERROR4', it means the totalizer values are lost, and the values saved upon the next to last power down are retrieved. Try restarting the device.
What does 'ERROR6' mean on Bürkert Measuring Instruments and how to fix it?
If the Bürkert Measuring Instruments displays 'ERROR6', it means totalizer values are definitely lost and both totalizers are reset. Start the device again.
What does 'WARN. LO' mean on Bürkert Measuring Instruments and how do I resolve it?
If the Bürkert Measuring Instruments displays 'WARN. LO', the measured flow rate has stayed under the minimum threshold for the set time delay. Check the flow rate in the pipe and its consequences on the process. If necessary, clean the flow sensor.
Why is the displayed flow rate not stable on my Bürkert Measuring Instruments?
If the displayed flow rate of your Bürkert Measuring Instruments is not stable, ensure there is fluid in the pipe and choose a higher filter value.
How to troubleshoot a Bürkert Measuring Instruments that does not properly measure the flow rate?
If the Bürkert Measuring Instruments device does not properly measure the flow rate, check that the K factor corresponds to the fitting used. You may also need to carry out a Teach-In procedure to determine the K factor of the fitting used.
How to fix a Bürkert Measuring Instruments display that is OFF?
If the Bürkert Measuring Instruments display is off, ensure the red and black wires are correctly wired to the terminal block. Also, verify the power supply switch is set to ON and the batteries are correctly positioned. If it remains off, replace the batteries.
Why does the displayed flow rate change very slowly on my Bürkert Measuring Instruments?
If the displayed flow rate on your Bürkert Measuring Instruments changes very slowly, ensure there is fluid in the pipe and choose a lower filter value.
What to do if my Bürkert Transmitter shows 'PWR FAIL'?
If the Bürkert Transmitter displays 'PWR FAIL', it indicates that the supply voltage is too low. This could be because the voltage at the device terminals is below 12 V or the impedance of the current measurement loop is too high. To resolve this, adjust the supply voltage to ensure the voltage at the device terminals is between 12 V and 36 V.
General| Display | LCD |
|---|---|
| Protection Class | IP65 |
| Output | 4-20 mA |
| Output Signal | 4-20 mA |
| Material | Stainless steel |
| Operating Temperature | -15 to +80 °C (depending on material) |
To Next Page
