Why does my Bürkert Transmitter show 'PU L LIM'?
If your Bürkert Transmitter displays 'PU L LIM', it indicates that the pulse value times the K-factor of the device is less than 1, meaning the entered volume for a pulse is too low. To resolve this, enter a higher volume per pulse and check the K-factor value.
Why does my Bürkert Transmitter show 'PU H LIM'?
If the Bürkert Transmitter displays 'PU H LIM', it means that the pulse value times the K-factor of the device is greater than 1000000, indicating that the entered volume for a pulse is too high. To fix this, enter a lower volume per pulse and check the K-factor value.
What to do if my Bürkert Transmitter displays ERROR 6?
If your Bürkert Transmitter displays 'ERROR 6', it means a memory read error occurred, resulting in the loss of totalizer values. To fix this, press the ENTER key to acknowledge the error. This action will reset the totalizers.
What to do if my Bürkert Transmitter displays ERROR 7?
If your Bürkert Transmitter displays 'ERROR 7', it indicates a memory read error where the user settings and the totalizer values are lost. To solve this, press the ENTER key to acknowledge the error: the totalizers are reset. After that send the device back to your supplier.
What to do if my Bürkert Transmitter displays ERROR 4?
If your Bürkert Transmitter displays 'ERROR 4', it signifies a memory read error where the totalizer values are lost. To resolve this, press the ENTER key to acknowledge the error. The values of the totalizers are then set to those of the last start of the device. Make sure you check the values of the totalizers.
What to do if my Bürkert Transmitter displays ERROR 3?
If your Bürkert Transmitter displays 'ERROR 3', it indicates a memory read error, meaning the user settings are lost. First, switch the device off and then on again. If the message persists, press the ENTER key to acknowledge the error, which will allow the device to operate with the default settings. Readjust the device. If the error message appears frequently, it's recommended to send the device back to your supplier.
What to do if my Bürkert Transmitter displays ERROR 5?
If your Bürkert Transmitter displays 'ERROR 5', it means there's a memory read error, and both the user settings and totalizer values are lost. To address this, press the ENTER key to acknowledge the error. The device will then operate with the default settings, and the totalizer values will be set to those of the last start. You should then adjust the device again and check the totalizer values. If the message appears frequently, it is recommended to send the device back to your supplier.
General| Category | Transmitter |
|---|---|
| Power Supply | 12-36 V DC |
| Measuring Principle | Electromagnetic |
| Pipe Diameter | DN 06 to DN 400 |
| Protection Class | IP65 |
| Display | Yes |
| Output Signal | 4-20 mA, Pulse, Frequency, Relay |
| Temperature Range | -10 to 60 °C |
| Process Connection | Threaded, flanged, or clamped |
| Wetted Materials | Stainless steel, FKM |
| Medium Temperature | -10 to 100 °C |
| Housing Material | Stainless steel, Plastic |
| Relative Humidity | 5-95% non-condensing |
| Accuracy | ±0.5% of reading |
To Next Page
