Burkert 8045 - Description; Area of Application; General Description

13
8045
ENGLISH
INSTALLATION
3.4.2 18-30 VDC with relays
The electrical wiring of this model is possible via the use of 2 cable glands. Remove
the cover via the screws on the front display and pull the cables through the PG 13.5s
and wire according to pin assignment diagram below (Fig. 3.5).
Switch 1
Switch 2
Fig. 3.5 Pin assignment for relays
The device can be easily connected to a PLC independently of the respective
version.
3.4.3 Switch Settings
Switch1: This switch allows a sinking or sourcing PLC to be connected (output
current). For further information see section 3.4.1.
Switch2 :
l This switch allows the Enter key to be locked to avoid accidental
or unauthorized access to the Programmation and Test menus.
l The Switch2 when set in the unlocked position allows the
parameter values to be changed (K-Factor, relays, current, ...)
and when in the locked position access to the programmation and
test menus is restricted.
3.4.2
4-20 mA
18-30 VDC
+
-
-
+
I
230 VAC
230 VAC
REL 2
REL 1
R2
R1
R2
R1
3 A
3 A
m
P+
P-
Power
supply