Burkert 8045 - Installation and Commissioning; Safety Instructions

21
8045
ENGLISH
CALIBRATION
4.4 CALIBRATION MENU
PRESS SIMULTANEOUSLY FOR 5 SECONDS
The internal Switch2 must be set in the unlocked position to enter parmeters
within this menu. (§ 3.4.3)
The following parameters can be set within this menu: SECTIONS
The following sections explain how to change the parameter values within the
calibration menu above.
0......9
ENTER
LANGUAGE
UNIT
K-FACTOR
CURRENT
PULSE
RELAY
FILTER
TOTAL
FREQUENC
END
Selection between English, German,
French, Italian and Spanish.
Selection of engineering units to
display flowrate and totalizer.
Input of K-factor according to chart or
Teach-in function in order to determine
the specific K-factor.
Determination of 4-20 mA measuring
range.
Parameter definition of pulse output
(unit and volume).
Parameter definition of relays. This
message only appears if the relay
option has been installed.
Damping selection. There are 10 steps
available and 2 filtering modes.
Totalizer resetting.
Selection of the mains AC frequency
(50 or 60 Hz).
Return to operation mode and storage
of new parameters.
4.4.1
4.4.2
4.4.3
4.4.4
4.4.5
4.4.6
4.4.7
4.4.8
4.4.9
4.4