Burkert 8045 - Page 4

4
8045
ENGLISH
QUICKSTART
Unpacking
Verify
Ident. No.
Install the fitting
on the piping
Unscrew the 4
screws and open
Connect power
supply cable
Connect output
cable
Re-assemble the unit
and install onto the
fitting
Connect the earth to the
earthing screw
Turn on the
power
Check
display is 0
with no flow
Enter the
K-Factor
Program the Transmitter
This section provides a comprehensive installation and operation guide which will
assist with the commissioning of the 8045 Flow Transmitter.
2.1 INSTALLATION
O.K
Yes
No
No
Verification of items received
See section 6.6
Contact your local Bürkert
subsidiary
Ensure the power
supply is disconnected
before starting work.
Ensure that security
provisions are
considered with the
power cable and relay
circuit.
Pay attention to the
max. permitted load of
the output current
loop.
The sensor finger must
be immersed in fluid 24
hours before calibration
(section 4.5.3)
Immerse the transmitter
into the fluid and
perform a zero point
calibration
See section 4.4.3
See section 6.4
See section 3.4
See the next page.
2.1
See
section 3.3.1
See section 3.1