RTG SERIES TILLER 05/16 Maintenance Section 5-3
© Alamo Group.Inc.
MAINTENANCE
MAINTENANCE
VENT PLUG LOCATION
Remove Vent Plug to
install gear oil. Re-install vent
plug when oil is at proper
level.
SMALL INSPECTION PLUG
Remove and fill with gear oil until oil comes out this
hole and then place the plug back into the hole. DO
NOT fill past this point.
TOP GEARBOX
SIDE GEARBOX
1. Remove the vent plug on the top of the side gearbox and the small inspection plug at the
side of the gearbox.
2. Pour the gear oil into the vent plug hole slowly until the oil starts to come out of the small
hole on the side. DO NOT OVER FILL THE GEARBOX!
3. Replaces the small Inspection Plug and the Vent Plug. Clean up any excess gear oil.
VENT PLUG LOCATION
Remove Vent Plug to
install gear oil. Re-install vent
plug when oil is at proper
level.
SMALL INSPECTION PLUG
Remove and fill with gear oil
until oil comes out this hole
and then place the plug back
into the hole
.
DO NOT fill past this point.
To Next Page
Loading...
