Page 5
Tone controls
Adjust the Bass & Treble tone controls if required.
1: Press the TONE button (25) on the remote control.
2: The first adjustment is Bass. Use the VOL+/- buttons
to adjust.
3: Press the TONE button again to edit the Treble using
the VOL+/- buttons to adjust.
4: Press the TONE button once more to edit Volume
using the VOL+/- buttons to adjust.
DSP effects
1: Pressing the DSP button (28) repeatedly cycles
through a set of EQ presets to alter the sound field.
Choose from: Jazz, Rock, Classic, Pop, Live, Dance &
Off.
Loudness function
This function adds a rounder bass sound at low levels.
1: Press the LOUD button (29) on the remote to enable.
2: Press again to disable the effect.
Switching modes
To switch between the available modes : CD, DAB/FM
& AUX IN.
1: Press the SOURCE button (unit 3) to cycle through the
options or press the relevant button on the remote
control from CD, DAB/FM (press repeatedly to cycle
between DAB & FM) & AUX IN.
DAB (Radio) operation
Select DAB using either method described above.
1: After switching to DAB input mode for the first time a
full scan of DAB stations is performed automatically.
Scanning...
12
During the full scan mode, the LCD will display a slide
bar that indicates the progress of the scan, and the
amount of radio stations that have been found so far.
Once the scan has finished, the radio will select the
first alphanumeric station.
DAB (Radio) operation (cont)
NOTE: The station name will be shown on the top
of the display. Information about the DAB radio
station will be displayed on the bottom of the
display.
2: To listen to the located DAB stations use either
PREVIOUS
(8) or SKIP (9) on the unit, (22)
or
(32) on the remote to cycle through the stations.
When you reach the desired station press the PLAY/
PAUSE button (4, 20) or ENTER button (21) on the
remote to begin playback of that station.
NOTE: If no stations were found, or no DAB
stations can be received currently [No DAB
station] will be displayed. In this case you may
need to perform another station scan.
Positioning the antenna
Positioning of the aerial will influence the DAB signal
quality.
1: To find the optimum position, select the display signal
strength indicator by cycling through the display
modes using the INFO button.
BBC R1
2: Once the indicator is displayed, move the aerial and
observe the signal level as shown by the bar graph.
When you are happy with the positioning, perform an
auto-tune to capture all of the available stations.
Auto scan mode
1: To activate the full scan press the MENU button (19).
2:
When you see the <Aut
oscan>
option press the PLA
Y
/
PAUSE or ENTER button. The unit will search for all
available DAB stations that can be tuned.
User instructions
To Next Page
Loading...
