Page 7
Secondary services
On some occasions you will see a “>>” symbol directly
after the name of the station. This indicates that there
are secondary services available to that station.
These secondary services contain extra services that
relate to the primary station, e.g. a sports station
may want to add extra commentaries. The secondary
services are inserted directly after the primary station.
1: To activate a secondary service press the FFWD
(32) on the remote. You will see that the >> has
changed to a << to indicate you have selected the
secondary service.
Station list
< BBC R5L >> >
2: Press the ENTER or PLAY/PAUSE button to begin
playback of the service.
3: To return to the original service press the FRWD
(22) and then ENTER or PLAY/PAUSE.
Pruning
When the radio has performed a Scan in several
locations you may find there are stored stations that
you can no longer receive. This function automatically
removes them from the stored station list.
1: Press the MENU button in DAB mode, and use either
(8) or (9) on the unit, (22) or (32) on
the remote to find <Prune> Press the PLAY/PAUSE
button (4) on the main unit or ENTER button (21) on
the remote
2: Use the
/ buttons on the remote to select YES
and press ENTER or PLAY/PAUSE to select.
DRC ( Dynamic Range Control )
This causes the radio to reduce the dynamic range of
the audio signal. The purpose of this is to adapt the
dynamic range of the audio signal to listening in a noisy
environment.
NOTE: this is not available on some DAB stations.
1: Press the MENU button in DAB mode, and use either
(8) or (9) on the unit, (22) or (32) on the
remote to find <DRC> Press the PLAY/PAUSE button
(4) on the main unit or ENTER button (21) on the
remote.
DRC ( Dynamic Range Control ) (cont)
2: Choose between DRC off, DRC Low and DRC High
using either
(8) or (9) on the unit, (22) or
(32) on the remote.
3: Press the ENTER or PLAY/PAUSE button to save the
setting.
FM (Radio) operation
Select FM using either method described on page 5
Scanning for stations
1: You can scan up or down the frequency range
manually by pressing the
(22) or (32) buttons
on the remote or pressing the
(8) or (9)
buttons on the unit to increase or decrease the
frequency in 0.05 MHz increments. To scan through
the frequency range quickly press and hold the
(8)
or
(9) buttons on the unit or press the (23) or
(33) buttons on the remote
2: Once a station has been found, the scanning will stop
automatically. If no station is found, then the tuning
will stop once it has cycled through the entire FM
band (87.5-108MHz).
Scan Modes
When performing an scan you can set the sensitivity
level of the stations to be found. EG: strong signals only
or all stations.
1: In FM mode, press the MENU button, when <Scan
Setting> appears on the display press the ENTER or
PLAY/PAUSE button to view the submenu.
2: Use either
(8) or (9) on the unit, (22) or
(32) on the remote to select either ALL STATIONS
(which will detect any station, even with a weak
signal) or STRONG STATION (which will only detect
stations with a good signal strength). Press the
ENTER or PLAY/PAUSE button to select the required
option.
3: When you perform a scan as described in SCANNING
FOR STATIONS, only stations fitting the applied
setting will be detected.
User instructions
To Next Page
Loading...
