Bush DC826B - System Settings and Configuration

20
Using your All-in-one System
Let’s get started
Navigating the Menu
1. Press the MENU button on the remote control or press and hold the INFO/MENU button on
the unit to access the menu.
2. Rotate the dial on the unit or press Up or down button on the remote to select your choice.
3. Press the dial / the “Enter” button on the unit or Ok button on the remote to confirm your selection.
This instruction manual explains the basic instruction for operating this unit. Unless
otherwise stated, all operations described are based on main unit use.
Adjusting the volume
∞ Turn the VOLUME –/+ dial on the unit or press the VOL +/– buttons on the remote control to
increase/decrease the volume.
∞ If you wish to turn the sound o
, press the MUTE button on the remote control. Press the MUTE
button again or press the VOL +/– buttons on the remote control to resume normal listening.
System settings
1. Press and hold INFO/MENU button on unit or press the MENU button on the remote control
to access the menu.
2. Rotate the dial on unit or press Up or down button on the remote control to select System
settings and then press the “Enter” button on unit or OK button on remote control to confirm.
Equaliser
a default sound format or configure your own.
Press the EQ button on the remote to access the Equaliser menu.
Alternatively:
During System settings mode, rotate the dial to select Equaliser and then press
the “Enter” button to confirm.
1. The display will show: “Normal” – “Classic” – “Jazz” – “Pop” – “Rock” – “Speech” – “My EQ”
If you have selected a personalised sound format under the following entry, select MY EQ to take
over the sound format directly. “My EQ” (and then enter the “My EQ Setup” to set treble and bass)