10
CD mode
Check that your Micro Hi-Fi is in
CD mode. If you are not already
in CD mode, briey press and
release the ‘Mode’ button on the
front of the Micro Hi-Fi or on the
remote control, until you are in
CD mode (check the display).
‘LOAd’ and then ‘NO Cd’ will be
displayed.
Note: If there is already a CD in
the CD drawer, ‘LOAd’ will be
displayed and then after a short
delay the audio CD will begin to
play.
Play a CD
Your Micro Hi-Fi will play Audio
CDs as well as the following CD
types:
CD-Recordable (CD-R)
CD-Rewritable (CD-RW)
Note: It is not possible to play
DVD or computer CDs on your
Micro Hi-Fi.
1. Press and release the button
on the front of the Micro Hi-Fi to
the right of the CD tray, or on the
remote control, to open the CD
drawer. ‘OPEN’ is displayed.
2. Place an audio CD, label side
facing up, into the CD tray.
3. Press and release the button
on the front of the Micro Hi-Fi or
on the remote control, to close
the CD drawer.
‘CLOSE’, followed by ‘LOAd’ will
be displayed and then after a few
moments the rst track will begin
to play.
The track number and the
elapsed time for the track will be
displayed.
CD controls
You can use the following
controls on your Micro Hi-Fi and
on your remote control in CD
mode.
Play
Press and release the button
on the Micro Hi-Fi or the on
the remote control. The rst track
will begin to play and each track
number will be displayed as it is
played.
Pause
Press and release the button
on the Micro Hi-Fi or the button
on the remote control. The CD
will continue to rotate in pause
mode. Press and release the
or button again to continue to
play the track/CD.
Using the CD Player
To Next Page
Loading...
