10
Click to Return to the Table of Contents
WARRANTY
Disposal of Electric and Electronic Equipment
(Applicable in the EU and other European countries with separate collection systems)
This equipment contains electric and/or electronic parts and must therefore not
be disposed of as normal household waste. Instead, it should be disposed at the
respective collection points for recycling provided by the communities. For you, this
is free of charge.
If the equipment contains exchangeable (rechargeable) batteries, these too must be
removed before and, if necessary, in turn be disposed of according to the relevant regulations (see
also the respective comments in this unit’s instructions).
Further information about the subject is available at your community administration, your local
waste collection company, or in the store where you purchased this equipment.
FDA SAFETY
Complies with 21CFR1040.10 and 1040.11 except for conformance with IEC60825-1 Ed.3., as
described in Laser Notice 56, dated May 8, 2019.
Caution: There are no user controls, adjustments or procedures. Performance of procedures other
than those specified herein may result in access to invisible laser light.
•
This product contains no user serviceable controls.
•
This product must not be opened or modified by the consumer.
•
This product must be returned to the manufacturer for service.
Device specifications and design are subject to change without notice or obligation on the part of
the manufacturer.
Industry Canada Statement/Déclaration d'Industrie Canada:
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes: (1) le dispositif ne doit pas
produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris
un brouillage susceptible de provoquer un fonctionnement indésirable.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
The device does not contain any user-serviceable parts. Repairs should only be made by an
Authorized Bushnell Repair center. Unauthorized repairs or modifications could result in permanent
damage to the equipment, and will void warranty and your authority to operate the device under
Part 15 regulations.
Specifications and design are subject to change without any notice or obligation on the part of the
manufacturer.
©2024 Bushnell Outdoor Products
Bushnell,™, ®, denote trademarks of Bushnell Outdoor Products
www.bushnell.com
9200 Cody, Overland Park, KS 66214
Made in China
https://vistaoutdoor.com/patents
WARNING: AS WITH ANY LASER DEVICE, IT IS NOT RECOMMENDED TO DIRECTLY VIEW THE
EMISSIONS FOR LONG PERIODS OF TIME WITH A MAGNIFIED LENS.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Warning: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
TECHNICAL SPECIFICATIONS
Dimensions
4.75 x 1.7 x 3.25 inches
Weight 12 oz.
Ranging Accuracy
Accurate to +/- 1 yard
Range
5–1300 Yards / 5–1189 Meters
Magnication 7x
Objective Diameter
28 mm
Display
Dual Red & Black LCD
Power Source 3-volt lithium (CR-2)
Field Of View
330 ft. @ 1000 yards / 110 meters @ 1000 meters
Extra Long Eye Relief
15 mm
Exit Pupil 3.7 mm
Included Items
Premium Carrying Case and CR2 Battery
Radiation Exposure Statement / Déclaration d’exposition aux radiations:
This device complies with the Industry Canada portable RF exposure limit set forth for an
uncontrolled environment and is safe for the intended operation as described in this manual. Further
RF exposure reduction can be achieved if the product can be kept as far as possible from the user’s
body or if the device is set to a lower output power if such function is available.
Le produit est conforme aux limites d’exposition pour les appareils portables RF pour les Etats-Unis
et le Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux
expositions RF peut être augmentée si l’appareil peut être conservé aussi loin que possible du corps
de l’utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible si une telle
fonction est disponible.
CLASS 1 LASER PRODUCT
EN/IEC 60825-1 2014
FCC ID: 2ASQI-202250
IC: 24886-202250
CMIIT ID: 23J44P857780
KCC ID: R-R-x6S-202450
210-226334
96776/SDPPI/2024
14455
Click to read Bushnell Golf product
warranty and repair information.
To Previous Page
Loading...
