13
read the relevant section.
4.2.4 Time Lapse
Under time lapse mode, PIR will be turned off, camera won’t
shoot. And only shoot at the specific time. Users can set:
5s,10s,15s,30s,1min,2min,5min,10min,20min,30min,1h,2h,6h,12h,1
8h,24h.
This function can be turned off and camera will shoot when
detect movement. This set is useless when camera in monitor mode.
Time lapse time starting point is the point of shooting, so the
time lapse will have a logical limit on recording time. As shown in
the table below:
Video
Length
Shortest Interval
Duration
Video
Length
Shortest Interval
Duration
5s 15s 1min 2 min
10s 30s 2min 5 min
15s 30s 3min 5 min
20s 30s 5 min 10 min
30s 1min 10min 20 min
45s 1min
Note: There is a logical association between video length and PIR
sleep. Please read the relevant section.
4.2.5 Stamps
On/Off mode, If turned on, the bottom of each photo will
show LOGO, temperature, moon phase, photo number.
4.2.6 Illumination
Users can set illumination level based on requirement. There
are three levels: weak illumination, normal illumination, strong
illumination. Users can choose different level based on different
condition. For example, it’s ok to use weak illumination when shoot
close-range or external bright place; better to choose strong
illumination when shoot distant objects or dark outdoors.
Also allows camera to adapt to the environment automatically
adjust light.
To Next Page
Loading...