28
EN
Bü ner Elektronik – MT iQ Basic
EN
28 Mobile Technology – MT iQ Basic
3 Installation MT iQ Basic
For the installation,
please remove all cables
from the pole terminal
of your battery's positive
pole.
Now pass these cables
through the opening in
the Hall sensor of the
battery computer. The
arrow of the Hall sensor
must here show in the
direction of the battery.
Subsequently reconnect
all cables to the pole
terminal.
+
Important!
All incoming or outgoing positive lines must
be passed through the sensor. This must also
be complied with if more than one on-board
battery is provided. Principally pass all
positive lines through the sensor. It might
possibly be helpful to run the various positive
lines to a support point and go with one joint
cable through the sensor and further to the
battery pole.
!
To Next Page
Loading...
