What to do if my CAB Printer prints a series of characters instead of the label format?
If your CAB Printer prints a series of characters instead of the label format, it might be in Monitor mode. To resolve this, exit Monitor mode.
Why is the print image blurred or missing in places on my CAB Printer?
If the print image from your CAB Printer is blurred or missing in places, there might be several reasons: * The printhead could be dirty. * The temperature might be too high; decrease the temperature via software. * You might have an unfavorable combination of labels and transfer ribbon; try using another ribbon type or brand.
What to do if my CAB Printer transports the label medium, but not the transfer ribbon?
If your CAB Printer transports the label medium but not the transfer ribbon, it could be due to: * The transfer ribbon being loaded incorrectly; check the course of the transfer ribbon and the orientation of the covered side, correcting if necessary. * An unfavorable combination of labels and transfer ribbon; try using another ribbon type or brand.
Why doesn't my CAB Printer stop when the transfer ribbon is done?
If your CAB Printer does not stop when the transfer ribbon is done, it is possible that direct thermal printing is selected in the software. To fix this, switch to thermal transfer printing in the software.
Why is my CAB Printer printing lighter on one side?
If your CAB Printer is printing lighter on one side, it could be caused by: * A dirty printhead. * The head locking system not being adjusted.
Why are there vertical white lines in the print image of my CAB Printer?
If you see vertical white lines in the print image of your CAB Printer, it could be due to: * A dirty printhead. * A defective printhead (failure of dots).
Why does my CAB Printer print only every second label?
If your CAB Printer prints only every second label, the format setting in the software might be too large. To solve this, change the format setting in the software.
General| Print Method | Thermal transfer |
|---|---|
| Resolution | 203 dpi |
| Interfaces | USB, Bluetooth |
| Memory | 8 MB |
| Sensors | Label gap sensor, black mark sensor |
| Options | Cutter |
To Next Page
