CAB A+ User Manual

16
17
4 Conguration
Parameter Meaning Default
Backfeed
Method for backfeeding the label medium.
Backfeeding is necessary in the cutting and peel-off modes since a
label is pushed out passed the front edge of the next label above the
print line when peeling off/cutting.
always: Backfeeding occurs independently of label contents.
smart: Backfeeding only occurs when the next label is not yet fully
prepared when peeling off/cutting the current label. Otherwise, the
second label is pushed on and completed after removal of the rst
label without backfeeding.
smart
Backfeed
at PX only
Printhead behavior during label backfeed.
head lift-off: Printhead will be lifted away from the print roller
head down: Printhead remains down on the print roller
head
lift-off
Error-Reprint
On: With a correctable error and corresponding troubleshooting, the
label being printed when the error occurs is repeated.
Off: Print job is continued with the next label.
On
Pause reprint
Printing of another label with the information of the previous print job
by pressing the pause button. This function can be executed until the
print buffer is cleared with the cancel button.
Off
Protocol error
On: Printer switches to Error mode when unknown or faulty data is
received.
Off: When working with older computer operating systems, it is
possible that the print spooler of the operating system will reply to the
printer with normal status messages of the printer (e.g. end of paper)
in the form of ASCII text. The printer cannot interpret this data and
outputs a large number of protocol errors. In this case, it is advanta-
geous to set the Protocol error parameter to Off.
!
Attention!
If the Protocol error parameter is set to Off,
protocol errors which can be traced back to faulty
programming are also ignored. There is a risk of data
loss.
Access only when service key is inserted!
On
Barcode error
On: With faulty barcode contents or size specications, printing is
interrupted.
Off: Printing is not interrupted if an error occurs. If barcode contents
are faulty, the printer attempts to replace the incorrect data with valid
characters (e.g. zeros). If barcode size specications are faulty, a
gray area is printed instead of the barcode.
On
Width ASCII dump
Width of the printing area in the ASCII Dump test function ( ”5.7”
on page 34).
With the Automatic setting, the printout of the control sequences
arriving at the printer occurs over the maximum printing width. The
printing area width can be reduced down to 50 mm.
Automatic
7 Parameters of the menu Setup > Print param.Table

CAB A+ Specifications

General

Brand	CAB
Model	A+
Category	Label Maker
Language	English