How to fix CAB MACH2 when label stock passes through but no image is printed?
If the label stock goes through the CAB Label Maker but no image appears, make sure the label stock is loaded correctly and is a suitable material. Also, verify that you've selected the correct printer driver and have chosen the appropriate label stock and printing mode.
What to do if there is no printed image on some parts of the CAB label?
If parts of the label are missing the printed image when using your CAB Label Maker, check the thermal print head for any stuck label material or ribbon. Also, check the application software for errors, verify that the starting position is set correctly, and inspect the ribbon for wrinkles.
Why is the printed image positioned incorrectly on my CAB MACH2?
If the printed image is not positioned correctly on the CAB Label Maker, check the sensor for any paper or dust. Also, verify that the label stock is suitable (contact your supplier if needed) and check the paper guide settings.
What to do if the label stock jams during printing in CAB Label Maker?
If the label stock jams during printing with the CAB Label Maker, clear the paper jam. Remove any label material left on the thermal print head and clean the print head using a soft lint-free cloth dipped in alcohol.
Why is the image blurred or missing on my CAB Label Maker?
If there's no printed image on part of the label or the image is blurred when using your CAB Label Maker, examine the thermal print head for dust or other dirt. You can also use the internal “~T” command to see if the thermal print head will carry out a complete print job and check the quality of the print medium.
How to fix a blurred printed image on CAB MACH2 Label Maker?
If the printed image is blurred on your CAB Label Maker, check the darkness setting and inspect the thermal print head for dust or dirt.
Why is CAB Label Maker missing a label during printing?
If a label is missed during printing on the CAB Label Maker, check the label height setting. Also, check the sensor for dust and run the auto-detection function.
What to do if the present sensor is not functioning normally on CAB MACH2?
If the present sensor is not functioning normally on your CAB Label Maker, check the sensor for dust and make sure the label stock is positioned correctly.
Why are labels not fed through or cut off correctly when using the cutter on CAB MACH2?
When using the cutter and the labels are not fed through or cut off incorrectly on your CAB Label Maker, check whether the cutter has been correctly installed and whether the paper guides are functioning correctly.
How to fix CAB Label Maker cutter that doesn't cut labels straight?
If the cutter on your CAB Label Maker does not cut off the labels in a straight line, check whether the label stock is positioned straight.
Details safety precautions for operating the device, including electrical hazards and warnings.
Details the procedure for connecting the printer to the power supply.
Explains how to connect the printer to a computer via USB or Ethernet.
Details the initial steps for installing the ribbon module.
Guides users through loading and replacing the label stock, including adjusting guides.
Details the steps for installing the printer driver from the product DVD.
Explains how to install the cablabel S3 Lite software for label design.
Covers using the Mach1/2-Load tool to configure printer settings and interfaces.
Describes how to perform automatic label calibration and a self-test for the printer.
Lists common error messages, beep codes, and their corresponding solutions.
Offers solutions for common problems encountered during printer operation.
General| Brand | CAB |
|---|---|
| Model | MACH2 |
| Category | Label Maker |
| Language | English |
To Next Page
