CAB MACH2 - 8 Accessories

40 40
8 Accessories
8.1 Preparation Steps
i
Note!
The accessories, Present Sensor and cutter, can only be installed separately.
They cannot be combined.
Open the Printer
2
1
Fig. 22 Open the printer
 Placetheprinteronaatsurface.
 Pull the cover release catches (1) on both sides of the printer.
 Raise the cover of the casing (2) and lock it into the catch.
Remove the front cover
3
Fig. 23 Remove the front cover
 Pull upward to remove the front cover (3).