CAB EOS2 - Reflex Mark Dimensions

24 24
8.3 Reex Mark Dimensions
Feed direction
virtual label front edge
reex mark
Labelswithreexmarks Endlessmaterialwithreexmarks
Figure 20 Reexmarkdimensions
Dim. Designation Dim. in mm
A Label distance > 2
AZ Distance between print zones > 2
L
Widthofreexmark > 5
M
Heightofreexmark 3 - 10
XM Distance mark - middle of paper track -58 - 0
Z Distance virtual label front edge - actual label
front edge
 Adjust software settings
0 up to A / recommended : 0
• Reexmarksmustbeonthebacksideofthematerial(liner).
• Labelsensorforreexmarksonthetopsideonrequest.
• Specicationisvalidforblackmarks.
• Recognition of colored marks may fail.  Preliminary tests are needed.
Table 10 Reexmarkdimensions
i
Note!
In case of translucent label material, reex marks can be detected not only by the reective sensor but also
by the gap sensor.
8 Media