Caberg just speak - 3 Functions; Basic Functions

38
ENGLISH
UK
3.1 Basic functions
All CABERG JUST SPEAK functions are activated by using the three but-
tons, - + .
Every command is confirmed by a special tone. This can change according to the
function requested. The type of command given to the system depends on how
long the button is pressed.
Each of the three system statuses is indicated by a different LED flash pattern:
blue/red/blue LED: battery needs charging
Rapid alternating red/blue flashing: the system is in pairing mode and
can be detected by another CABERG JUST SPEAK kit or other bluetooth
®
compatible unit.
Slow blue flashing: the system is operative.
Warning: listening to the unit should not distract the
motorcycle rider from control of the vehicle. This has
absolute priority. In line with Highway Code guidelines,
the motorcycle should be stationary when making all
adjustments to electronic equipment and the CABERG
JUST SPEAK system.
Switch on Press and hold the button for about 4 seconds, until the
LED fl ashes and “on” tone is heard in the headset (high tone).
Switch off Press and hold the button for about 4 seconds until the LED
shines steadily and “off” tone is heard in the headset (low tone).
Increase volume
Press + button briefl y to increase volume. A high tone
sounds when maximum volume is reached.
Decrease volume Press - button briefl y to decrease volume. A low tone
sounds when minimum volume is reached.
3 FUNCTIONS