Caberg just speak - Functions with Bluetooth Intercom

44
ENGLISH
UK
3.3.2 Functions with Bluetooth
®
intercom
Switch on both CABERG JUST SPEAK systems. When the rider’s helmet is
switched on it will seek the passenger’s system and automatically establish
an intercom channel.
Note: So that the connection is made automatically when the systems are
switched on, we advise switching on the CABERG JUST SPEAK system
mounted on the passenger helmet first, then the rider’s system.
Note: Some Bluetooth
®
devices already connected to the system can
block the automatic connection described above. If this happens, con-
nect manually by pressing the button briefly.
It is possible to activate and deactivate intercom communications at any time
by pressing the
button briefly on either of the two CABERG JUST SPE-
AK systems.
Note: the CABERG JUST SPEAK may take several seconds to find the
other system, depending on connections already active and the Blue-
tooth
®
devices present. After pressing the button, leave enough time
for the search process to be completed.
Note: If Bluetooth
®
connection does not take place automatically, simply
press the
button briefly on either helmet to activate search and con-
nection.
When two CABERG JUST SPEAK systems become too far apart, the audio
quality deteriorates significantly and the connection between the two is lost.
Activate/deactivate
intercom mode
Press button
briefl y. The system may
take a few seconds to detect the other CA-
BERG JUST SPEAK.
3 FUNCTIONS