9030920 E6 Event and Alarm Messages
4-3
SynOptics Series 3000 Events and Alarms
This table describes the event messages appearing in the Event Log, and any corresponding
CsEvFormat/Event36000103
{d "%w- %d %m-, %Y - %T"} - An
Ethernet board power supply failure
has been detected. The power supply
status is {I}.
CsPCause/Prob36000103
An Ethernet board power supply failure
has been detected.
CsEvFormat/Event36000104
{d "%w- %d %m-, %Y - %T"} - A port
auto-partition condition has been
detected. The port partition status is {I}.
The port jabber status is {I}.
CsPCause/Prob36000104
A port auto-partition condition has been
detected.
CsEvFormat/Event36000106
{d "%w- %d %m-, %Y - %T"} - The NMM
is dropping packets due to an overload.
The Rx status is {I}.
CsPCause/Prob36000106
The NMM is dropping packets due to an
overload.
CsEvFormat/Event36000107
{d "%w- %d %m-, %Y - %T"} - A change
has been detected in the operating
status of a local bridge port. The port
status is {I}.
No probable cause message
CsEvFormat/Event36000108
{d "%w- %d %m-, %Y - %T"} - A local
bridge failure has been detected. The
most recent LED diagnostic status is
{O}.
CsPCause/Prob36000108
A local bridge failure has been detected.
CsEvFormat/Event36000109
{d "%w- %d %m-, %Y - %T"} - A change
has been detected in the operating
status of a remote bridge port. The port
status is {I}.
Not Applicable
CsEvFormat/Event3600010a
{d "%w- %d %m-, %Y - %T"} - A remote
bridge failure has been detected. The
most recent LED diagnostic status is
{O}.
CsPCause/Prob3600010a
A remote bridge failure has been
detected.
Table 4-1. SynOptics Series 3000 Events and Alarms (Continued)
Message in the Event Log
Alarm View Probable Cause
Message
To Next Page
Loading...